The CaseLube™ Technical Data Sheet provides detailed physical properties, friction characteristics, drying time, and application guidance for this colloidal graphite case neck lubricant used in precision ammunition reloading applications.
Application
CaseLube™ is a precision dry film lubricant formulated for cartridge case neck lubrication in precision ammunition reloading applications.
Its ultra-thin, adherent graphite film:
-
Reduces galling during sizing
-
Promotes consistent neck tension
-
Enhances uniform bullet release
-
Minimizes dimensional change
-
Improves consistency in ballistic performance
The cured film provides dry lubrication and conductivity without buildup or measurable thickness variation when properly applied.
Composition
Processed micro graphite, thermoplastic resin, and isopropanol.
Properties
Non-corrosive, abrasion-resistant, high chemical purity, and conductive. Suitable for precision metal-to-metal applications where dry lubrication is required.
Physical Properties
- Physical State: Thixotropic gelColor: Black
- Temperature Range: -70°F to 400°F (-57°C to 204°C)
- Flash Point: 52°F (11.1°C), Pensky-Martens Closed Tester
- Density: 6.6 lb/gal (0.8 kg/l)
- VOC: 766 g/l (6.4 lb/gal)
Film Properties (As Cured)
- Color: Black
- Coefficient of Friction: 0.19 (Static)
- Service Temperature Continuous: 400°F (204°C)
- Intermittent Temperature: 850°F (454°C)
- Sheet Resistance: <2400 ohms/sq @ 25µm dry film thickness
Recommended Applications
- Cartridge case neck interior lubrication
- Projectile coating (light, uniform application)
- Die contact surfaces during sizing
- Reduction of static buildup in reloading environments
Application Instructions
Supplied ready for use. Mix thoroughly before application.
Apply a thin, even film using:
- Lint-free polyurethane foam applicator
- Non-abrasive foam swab (recommended size C5709C)
- Fine brush
- Dip method (light contact only)
Allow to air dry before sizing or seating.
Typical dry film thickness: 0.2 – 0.5 mil.
Surface Preparation
Ensure cases and projectiles are clean and dry before application. Remove oils and debris prior to coating.
Dry Time
Air dries to touch in approximately 5 minutes.
Ready for use in approximately 30 minutes.
Storage
Store in a cool, well-ventilated area away from heat and ignition sources. Keep container tightly closed.
Health & Safety
Flammable. Harmful if swallowed, inhaled, or absorbed through skin.
Refer to Safety Data Sheet for complete hazard and handling information.
Packaging
Available in 2 oz bottle and other industrial sizes.
Disclaimer
Information provided is believed to be reliable but is offered without warranty. User is responsible for determining suitability for intended application.